Second Wind Air Purifiers Installation Manual 2414 2414-S 24 Volt Remote Units
Index: Page Product 2 Safety Procedures 2 Mounting Location 3 Tools 3 Installation Installation Remote Lamps 4 5 Lamp Replacement/Disposal And Parts List 6 Troubleshooting Warranty 7 7&8 All Second Wind air purifiers are designed to address Heating and Air Conditioning air handling units. Second Wind air purifiers use ultraviolet germicidal light at a frequency of 254 nanometers to disinfect biological growth in return or supply air stream .
1. 2. 3. 4. Install the lamp where you have easy access. Make sure before drilling into equipment that there is nothing in the way that would be damaged. The lamp should be installed a minimum of 2-3 inches, maximum 36 inches away from the coil or pan surface. When looking for a mounting location try to install the unit away from non UV resistant plastics, rubber, and other non metallic materials. Shield these components using sheet metal, aluminum tape, or metal conduit.
• The installation should be done by a qualified HVAC contractor. Unit must be installed in compliance with all national and local electrical and mechanical codes. Failure to do so will void UL safety listing and Second Wind warranty. Read all safety instructions at the beginning of this manual. Failure to do so could lead to personal injury and/or equipment damage.
The Second Wind Ultraviolet Germicidal Photo-catalytic 24 Volt Lamp is designed for 9000-11,000 hours of continuous operation. After 9000 hours intensity of the lamp inside the duct diminishes and should be replaced. Even if the lamp is still illuminated replacement of the lamp is recommended, by a qualified HVAC Service Technician. • 1. 2. 3. 4. 5. The installation should be done by a qualified HVAC contractor. Disconnect electrical service and turn unit off. Remove screws from remote lamp connector.
If the unit does not work, check the following: Electrical Supply/Wiring—Verify that the electrical service is operating correctly. Lamp—Verify that the lamp is not broken and is properly seated in the lamp connector. To check this, follow steps in the ’Lamp Replacement’ section with one exBallast—If lamp still is not illuminating check the wir- ception: you should not remove and replace the lamp. ing to the ballast.
WARRANTY LIMITATIONS This warranty will be voided if the covered equipment (only Second Wind replacement parts or units are warranted) is removed from the original installation site. This warranty does not cover damage or defect resulting from: 1 Accident, or neglect or unreasonable use or operation of the equipment, including operation of electrical equipment at voltages other than the range specified on the unit name plate.
24 volt Power White wire– 24 VAC Red Black Wire– 24 VAC Black
