Product Manual

7
Battery Installation / Charging
Built-in overcharging protection prevents damage if the unit is left on charge
after being fully charged. There is also protection to prevent charging alkaline
batteries.
CAUTION: Do not attempt to charge alkaline or other
disposable batteries.
NOTE: Do not charge Ni-MH batteries when ambient temperature
exceeds 113° F (45° C) or is less than 32° F (0° C).
The rechargeable battery electronics include a charge status and charge error
indicator located on the back of the housing.
Charge Status Indicator: The LED will remain solid when the unit is charging.
The LED will blink when fully charged. When charged, unplug the charger from
the outlet and remove the cannon adapter from the accessory connector.
Charge Error Indicator: If the batteries seem to be in a totally drained state
initially, the charge circuit will try to gradually charge the batteries. If charging
is unsuccessful after approximately 20 minutes, the LED will turn on solid
indicating an error with the internal battery connection, improper battery
insertion, the wrong type of battery, or a dead battery cell.
A blinking charge error LED indicates the unit is too hot or too cold to charge.
Charging will automatically start when the temperature is within the above
noted ranges.
Battery Replacement - Remove dust cap, loosen thumbscrews, and remove
battery access cover. Remove old batteries. Install new batteries as described
on previous page.
Refer to your local requirements for the proper disposal of batteries.
(Located on lower rear of polycarbonate housing)
Charge Status Indicator
Solid - Charging
Blinking - Charging Complete
Charge Error Indicator
Solid - Battery Problems
Blinking - Temperature
out of limits
Battery Installation / Charging
Battery Installation: Remove the BULLSEYE from its carrying case. Hold the
unit so the accessory connector is pointing upwards. Remove the dust cap from
the accessory connector. Loosen the two thumb screws and remove the battery
access cover. Install four batteries as shown on the label diagram inside the
battery compartment noting the (+) and (-) terminals.
Battery installation diagram /
Serial number label
6
Replace the battery access cover. Firmly tighten the two thumbscrews. Ensure
the battery access cover is aligned and fully engaged into the battery housing.
Use a screwdriver if necessary. Replace the accessory connector dust cap.
Nickel Metal Hydride (Ni-MH) Batteries: Batteries are initially shipped fully
charged but the charge may decrease over time prior to first use. They may
require 2 or 3 charging cycles to obtain maximum battery life. To charge, remove
the dust cap from the accessory connector. Insert the cannon adapter into the
receiver accessory connector aligning the slot and connector key. Insert the
charger female barrel connector into the cannon adapter.
Assure the proper AC prongs are on the charger. To change the prong
configuration, press the tab release and remove the existing prong adapter.
Align the key slots and press in the proper adapter.
Plug the charger into an appropriate outlet. Do not operate the receiver when
it is charging.
The batteries may also be charged with the 12-volt auto lighter adapter.
Cannon
Adapter
Charger
Prongs
Tab
Release