Product Manual

Controls and Displays
1. Aluminum cast upper and lower
housings.
2. Polycarbonate housing - protects
the electronics.
3. Receiving Windows - four sets of
photocells equally spaced to allow 360
degree reception.
4. Ultra-bright LED array - highly visible,
graphically displays blade or bucket
position. Green on-grade LED's and
red off-grade LED's for quick visual
indication.
5. Set-up length scale - used for initial
set-up in wide Angle Compensation for
Excavation (ACE) mode.
6. Power Switch - turns the unit on and
off. Also operates as a "shift" key for
secondary receiver functions.
7. Liquid Crystal Display - Indicates
current receiver settings and battery
status.
8. Touchpanel Switches - allow adjust-
ment of settings.
9. Mounting Knobs - large knobs
attached to stainless steel clamps allow
for quick and easy installation to mast or magnetic mount.
10. Access screws - allow easy access to battery compartment for
replacement of batteries.
11. Accessory Connector and Dust Cap - connector accepts the cable
to the optional remote display, machine power cable, or automatic
control box. Connector also accepts Ni-MH battery charger. Dust
cap helps keep the connector clean.
4
1
3
2
7
6
5
8
9
10
4
11
5
Controls and Displays
Power Switch
Laser Out
of Level
Selection
Plumb
Selection
Averaging
Selection
Center / Offset
On-Grade
Selection
Accuracy
(Deadband)
Selection
Display
Brightness
Selection
Communication
Link (Not Used)
Touch Panel
Lock
Touch Panel
Touch Panel
Lock
Out of Level,
RPM Indication
Averaging
1-2-4
Display
Brightness
Selection
Accuracy
(Deadband)
Selection
Center or
Offset
On-Grade
Plumb
Selection -
Standard,
Wide (ACE), Off
Battery Status
Communication
Radio Link
(Not Used)
LCD
LCD