Product Manual

Safety
Meaning of Symbols:
WARNING: Indicates a potential hazardous situation, which
could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation, which
could result in a minor or moderate injury and/or material,
financial, or environmental damage.
NOTE: Important information to enable the product to be used
in a correct and efficient manner unrelated to safety.
The user of this product is expected to follow all operating
and safety instructions of this manual and of the machinery
operator's manual. Perform periodic checks of the product's
performance. The manufacturer or its representatives
assume no responsibility for results of the use of this product
including any direct, indirect, consequential damage, and loss
of profits. Check your work frequently.
WARNING: When working near construction or agricultural
machinery, follow all safety precautions as described in the
machinery's user manual.
WARNING: When excavating, follow all excavation and trench
safety regulations and practices.
CAUTION: Be aware of all overhead obstructions and electrical
power lines. The receiver and mast may be higher than the
machinery. Remove when transporting machinery.
CAUTION: Do not disassemble any part of the receiver other
than to replace batteries. The receiver is to be serviced by
authorized Apache Technologies service personnel only.
2 3
System Description
The Apache BULLSEYE 6 laser receiver is a rugged, multipurpose, electronic
receiver that detects laser light generated by rotating laser transmitters. The
unit works with nearly all models of rotating lasers and will detect both visible
and invisible beams.
When installed, the operator is given visual indication of the reference plane of
laser light’s position relative to the cutting edge or digging depth of the machine.
The BULLSEYE can also be installed with an Apache Control Box for automatic
control on certain grading machines.
The operator can adjust the settings of the BULLSEYE to meet job site
requirements. Settings are provided for adjusting the dead-band size or accuracy,
on-grade location for grading or excavation, display brightness and more.
The ultra-bright, built-in LED display provides up to 8 channels of grade
elevation position, plus high and low lost beam indications.
Built in plumb indication allows for quick and accurate grade checks. The new
Angle Compensation for Excavators (ACE) also allows grade checking at extended
dipper arm swing angles once a simple set-up procedure is completed.
A tough sealed waterproof housing is designed to work in the tough machine
mounted environment. The electronics are isolated from the rest of the unit
by internal rubber shock-mounts, protecting the unit from shock and vibration
damage.