User Manual

ENFORCER 4-Channel CCTV “Brick” Power Supply
SECO-LARM U.S.A., Inc. 3
Installation:
1. Find a suitable location to install the power supply. The power supply should be installed
out of sight, and in a place protected from weather and high humidity. The power supply
must have adequate ventilation. Insufficient ventilation may cause overheating and
damage could result.
2. Attach the power supply to a wall or desk using the included mounting bracket. If
possible, mount the power supply sideways or with the terminals facing down so they do
not collect dust.
3. Connect the main power cable to the power supply.
Sample Installation:
Legend:
Positive (+):
Negative (–):
Installation:
Wiring and Adjusting Voltage:
1. Connect cameras and other devices to the power outputs, while observing correct
polarity as shown in Figure 1. To minimize voltage drop, use 18-gauge or larger wire.
WARNING: Always test output voltage before connecting devices to the power supply.
2. If voltage drop is large, adjust the output voltage potentiometer as shown in Figure 2.
Positive (+)
Negative (–)
Figure 1
ENFORCER
®
ENFORCER
®
ENFORCER
®
Figure 2
Min.
Max.