User Manual

ENFORCER Component Video Baluns
4 SECO-LARM U.S.A., Inc.
WARRANTY This SECO-LARM product is warranted against defects in material and workmanship while used in normal
service for a period of one (1) year from the date of sale to the original consumer customer. SECO-LARM’s obligation is
limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM.
This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect,
repair, or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines
that such equipment is not operating properly as a result of causes other than defects in material and workmanship.
The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to replacement or repair only,
at SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential
personal or property damages of any kind to the purchaser or anyone else.
NOTICE: The information and specifications printed in this manual are current at the time of publication. However, the
SECO-LARM policy is one of continual development and improvement. For this reason, SECO-LARM reserves the right
to change specifications without notice. SECO-LARM is also not responsible for misprints or typographical errors.
Copyright © 2009 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in
whole or in part, without the written permission of SECO-LARM.
SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606 Website: www.seco-larm.com
Tel: [phone] Fax: [phone] E-mail: sales @ seco-larm.com
mi-MVE-PCx12-5Q.docx
Troubleshooting:
Component video balun does not
function correctly
y
Make sure all input and output connections are
connected firmly to the
balun
y
Make sure the video input device is turned on
y
Make sure the video output device is turned on
y
Test the Cat5/6 cable between the baluns
y
Make sure the IR/Audio transmission switch is set
to the correct position
PITSW4
Also Available from SECO-LARM:
Passive Audio Baluns
HDMI over Cat5e/6
3.5mm Stereo Balun
MVE-AH010Q
MAE-P115-01Q
MAE-P317-01Q
SECO-LARM has a complete line of audio/video products.
Please visit www.seco-larm.com for more information.
(shown)
Component Video Baluns
MANUAL
MVE-PW015Q
The ENFORCER MVE-PC0 Series of Component Video Baluns extends the range of traditional
component video (YPbPr or RGB) signals. Used in pairs, the baluns use a single Cat5e/6 Cable to
deliver HD resolutions up to 1080p and a single digital audio or IR signal distances of up to 160’
(50m), or up to 1000’ (300m) for 480i. The MVE-PC0 Series can also be programmed to transmit
an additional digital single audio or IR signal.
MVE-PC015Q
Wall Plate
Standard
with Programmable Digital Audio or IR Transmission