Manual

ENFORCER HDMI
®
Extender over Single Cat5e/6
SECO-LARM U.S.A., Inc. 3
HDMI IN
HDM
I OU
T
HDMI IN
HDM
I OU
T
HDM
I OU
T
Receiver
1.
Determine the locat
ion where the MVE
-
AH1E1
-
4
2
NQ
units will be wired as well as how much Cat5e/6
cable will be necessary.
2. Connect the transmitter to the HDMI output of the source device.
3. Connect the Cat5e/6 cable to both the receiver and transmitter units.
NOTE: For maximum range use a Cat6 cable.
4. Connect the receiver to the HDMI input of the display device.
5. Connect the 12VDC adapter to either the transmitter or receiver depending on where you want to place it.
6. Determine which device, if any, will be controlled by the remote control. Install the IR transmitter to the
IR Tx port, pointing the IR transmitter at the device to be controlled. Install the IR receiver to the IR Rx
port of the other device, pointing the IR receiver to where the remote control will be. Point the remote
control at the IR receiver when in use.
7. Switch on the HDMI source and display to verify that the system is functioning properly.
8.
Switch on the HDMI source and display to verify that the
system is functioning properly.
Transmitter*:
*Transmitter and Receiver unit have the same dimensions
†
Input/Output are reversed on receiver
Cable Legend:
Cat5e/6
Power
IR HDMI
Overview:
Installation:
Sample Application:
HDMI Source
Cat5e/6
Up to 197' (60m) at 4K@60Hz
Up to 230' (70m) at 1080p
12VDC Power Supply
HDMI
Display
IR TX
IR RX
Remote
11
/
16
" (17mm) 3
7
/
16
" (88mm)
HDMI
IR Out
†
Service
Cat5e/6
12VDC
2
3
/
8
"
(61mm)