Manual

ManualsBrandsSECO-LARM ManualsUTP Transmission & Baluns4K HDMI Extender over Single Cat5e/6

MVE-AH1E1-42NQ

4K HDMI Extender over Single Cat5e/6

Manual

Up to 98

ft (300m)

Resolution

Up to

230ft

(70m)

Range

Cat5e/6

Single Cable

Plug

and

Play

Operation

Features:

 Extends HDMI over a single Cat5e/6 cable

 Supports resolutions from 480i to 4K with

zero signal loss

 Transmits 4K@60Hz up to 197' (60m) or

1080p@60Hz up to 230' (70m) over

Cat6 cable

 Plug and play operation

 Active operation ensures signal strength

 IR for remote control extension

 One (1) 12VDC power supply included –

set can be powered at either end

Summary of content (4 pages)

PAGE 1
MVE-AH1E1-42NQ 4K HDMI Extender over Single Cat5e/6 Manual Up to 4K 230ft Cat5e/6 Resolution Range Single Cable (70m) Plug and Play Up to 984ft (300m) Operation Features:  Extends HDMI over a single Cat5e/6 cable  Supports resolutions from 480i to 4K with zero signal loss  Transmits 4K@60Hz up to 197' (60m) or 1080p@60Hz up to 230' (70m) over Cat6 cable     Plug and play operation Active operation ensures signal strength IR for remote control extension One (1) 12VDC power supply included
PAGE 2
ENFORCER 4K HDMI® Extender over Single Cat5e/6 Introduction: The ENFORCER 4K HDMI Extender over Single Cat5e/6 extends the range of traditional HDMI cabling methods by using an active transmitter and receiver to send video and audio over a single Cat5e/6. HDMI formats as large as 4K can be transmitted up to 197ft (60m) between the two units with zero signal loss by using integrated circuits in the receiver and transmitter.
PAGE 3
ENFORCER HDMI® Extender over Single Cat5e/6 Overview: Transmitter*: HDMI IN Cat5e/6 HDMI HDMI OUT 23/8" (61mm) Service IR Out† 12VDC 11/ " (17mm) 16 *Transmitter and Receiver unit have the same dimensions †Input/Output are reversed on receiver 37/16" (88mm) Installation: 1. Determine the location where the MVE-AH1E1-42NQ units will be wired as well as how much Cat5e/6 cable will be necessary. 2. Connect the transmitter to the HDMI output of the source device. 3.
PAGE 4
ENFORCER 4K HDMI® Extender over Single Cat5e/6 IR: The MVE-AH1E1-42NQ supports IR pass-through signals. This allows for remote operation of the source device from the display location. The MVE-AH1E1-42NQ IR Transmitter unit and IR Receiver unit support signals from 30~60 kHz.