User Manual

ENFORCER 1U RACK-MOUNT 16-CHANNEL ACTIVE VIDEO BALUN HUB
6 SECO-LARM U.S.A., Inc.
Cable Management:
1. Screw the two included “G” brackets onto the mounting point on the rear of the unit with
the included M3x6 screws. Mount the brackets open end at the top.
2. Mount the brackets and route power cables in a way that best suits your installation. Be
sure to leave slack in the cable to ease future maintenance. Use cable ties (not
included) to reduce cable tension.
Cable tie
Cable management
“G” bracket
Adjusting the Image:
1. Locate the camera’s corresponding output on the front of the EVT-AH16-VT2Q.
2. Adjust the Contrast and Brightness adjustment knobs by hand.
Contrast
adjustment knob
Brightness
adjustment knob
Connecting to Ground:
To earth
ground
1. For best surge protection results, connect
the included ground wire to the ground
screw located on the back of the
EVT-AH16-VT2Q.
2. Connect the ground wire to earth ground.
(For example, a grounded metal conduit,
a cold water pipe, or a grounding rod.)