User Manual

ENFORCER 1U RACK-MOUNT 16-CHANNEL ACTIVE BALUN HUB

SECO-LARM U.S.A., Inc. 5

Wiring:

1. Connect the included 12VDC adapter to the EVT-AH16-VT2Q and to a power source.

2. Run a Cat 5e/6 UTP cable from each camera through the wall or through a conduit to

the EVT-AH16-VT2Q.

Note: If existing telecom or data UTP cables are available, they can be mixed and

matched with new cables. Running two or more cables together should not

affect the video signals.

3. Connect a video balun (use active transmitter for best results) to a pair of wires in the

UTP cable near the CCTV camera, and then plug the video balun into the camera.

Connect the matching pair of wires in the cable at the other end of the correct video-in

port on the back of the EVT-AH16-VT2Q.

Connecting to DVR, Video Switcher, or Multiplexer:

1. Run one coaxial cable (not included) from the Video Out or Video Loop port on the EVT-

AH16-VT2Q and connect it to the corresponding video-in port of the DVR, video

switcher, or multiplexer (not included).

2. Repeat the above as necessary until each used channel is connected to the DVR, video

switcher, or multiplexer.

EVT-AH16-VT2Q

DVR

Coaxial

cable

Cat5e/6

Using a Passive Balun

(EVT-PB1Q)

EV-2615-NKEQ

Using an Active Balun Transmitter

(EVT-TB1-42TQ)