User Manual

ManualsBrandsSECO-LARM ManualsCovert Cameras1080p 4-in-1 HD TVI, CVI, AHD, Analog Wall-Plate Camera, 2.9mm

ENFORCER 4-in-1 HD TVI, CVI, AHD, Analog Wall-Plate Camera

4 SECO-LARM U.S.A., Inc.

The screen is blank



Check that the camera is powered up

 Check that the power supply's polarity is correct

 Check that the monitor is powered up

 Check that the video cable connecting the camera to the monitor

is connected properly

 Verify video format

The screen image is dim



Clean the lens using a soft, clean cloth

 Change the position of the camera

 Verify video format

The screen image has poor contrast



Adjust the monitor's contrast knob

 Change the position of the camera

 Verify video format

The screen image flickers



Change the position of the camera

 Verify video format

The screen image is distorted



Change the position of the camera

 Verify video format

The camera case is hot



Check that the correct power supply is in use

Troubleshooting:

U.S.A., Inc.

16842 Millikan Avenue, Irvine, CA 92606

Website:

www.seco

larm.com

Phone: (949) 261

2999 | (800) 662

0800

Email: sales@seco

larm.com

ITSW1

Order Part# 764

100

MI_EV

Y5105

N2SQ_181207.docx

NOTICE

The SECO

LARM policy is one of continual development and improvement. For that reason, SECO

LARM

reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints. All t

rademarks

Inc. All

rights reserved.

WARRANTY:

This SECO

LARM product is warranted against

defects in material and workmanship while

used in normal

service for three (3) years from the date of sale to the original customer. SECO-

LARM’s obligation is limited to the repair or

replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM.

This Warranty is void if

damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration,

improper or abnormal usage, or faulty installation, or if for any other reason SECO-L

ARM determines that such equipment

is not operating properly as a result of causes other than defects in material and workmanship.

The sole obligation of

SECO-LARM and the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at SECO-LARM

’s

option. In no event shall SECO-

LARM be liable for any special, collateral, incidental, or consequential personal or property

damage of any kind to the purchaser or anyone else.

IMPORTANT

Users and installers of this product are responsible for ensuring this product complies

with all national,

state, and local laws and statutes related to monitoring and recording audio and video signals. SECO-LARM

will not be

held responsible for the use of this product in violation of any current laws or statutes.

FCC COMPLIANCE STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device

may not cause harmful interference, and (2) this device must accept any interference received, including interference that

may cause undesired operation.

Switching between HD Analog Outputs:

To set format via the OSD controller, press the

controller in the direction of the desired setting,

hold for 5 seconds, and release when the

camera restarts.

See chart to the right.

Direction

Format Setting

CVI

Down

TVI

Left

CVBS

Right

AHD

DOWN