User Manual

ManualsBrandsSECO-LARM ManualsCovert Cameras1080p 4-in-1 HD TVI, CVI, AHD, Analog Wall-Plate Camera, 2.9mm

EV-Y5105-N2SQ

4-in-1 HD TVI, CVI, AHD, Analog

Wall-Plate Camera

Manual

Features:



Select between multiple formats:

TVI, CVI, AHD, and Analog



2.8

" 2MP Sony STARVIS CMOS

 2.9mm Wide angle lens

 Weatherproof IP67 construction

 Vandal-resistant design



Adjustable mounting angle

 Includes: 1 camera, 1 single-gang plate,

1 slimline plate, and angled mounting rings

 2DNR (2D Digital Noise Reduction)

 D-WDR (Digital Wide Dynamic Range)

 12VDC Operating voltage

Summary of content (4 pages)

PAGE 1
EV-Y5105-N2SQ 4-in-1 HD TVI, CVI, AHD, Analog Wall-Plate Camera Manual Features:  Select between multiple formats: TVI, CVI, AHD, and Analog  1/2.8" 2MP Sony STARVIS CMOS  2.
PAGE 2
ENFORCER 4-in-1 HD TVI, CVI, AHD, Analog Wall-Plate Camera Specifications: Type Formats Plate type CMOS Resolution 2DNR D-WDR OSD (On-Screen Display) External OSD Control Scanning system Sync Video output Lens Viewing angle FPS F Stop Minimum illumination Gamma correction S/N Ratio Gain control Operating voltage Current draw IP Rating Operating temperature Camera Dimensions Single-gang plate Slimline plate Camera body weight Wall-plate camera TVI (Default) / CVI / AHD / Analog 1 Single-gang, 1 slimline 1/
PAGE 3
ENFORCER 4-in-1 HD TVI, CVI, AHD, Analog Wall-Plate Camera Before Starting: 1. Read this manual carefully and keep it for future reference. 2. Use the camera within given temperature and electrical limits. 3. Do not point the camera at the sun. Heat could damage the camera, even when not in use. Overview: Plate Angled rubber ring Aluminum hex nut 4. Do not mount the camera in areas exposed to radiation, strong magnetic fields, or strong electrical signals. 5. Do not open or disassemble the camera.
PAGE 4
ENFORCER 4-in-1 HD TVI, CVI, AHD, Analog Wall-Plate Camera Switching between HD Analog Outputs: To set format via the OSD controller, press the controller in the direction of the desired setting, hold for 5 seconds, and release when the camera restarts. See chart to the right.