Installation manual

Passive Video, Power, and Data Balun

Note: Products with model numbers that end with “Q” or that have a round green “Q” sticker are RoHS compliant.

Installation Manual

 Transmits up to 1,300ft (400m) color

video or up to 1,950ft (600m) B/W video

 Transmits power for 12/24 VAC/VDC

cameras (see pg. 3 for details)

 Transmits data up to 984ft (300m)

 High immunity from interference

 Includes DC plug and DC jack

 Pigtails for flexible installation

 Uses low-cost Cat5e/6 cable

instead of costly coaxial cable

 RJ45 Jack for easy installation

 Passive operation – No external

power required

 Built-in surge protection

EB-P101-20VQ

PAGE 1
EB-P101-20VQ Passive Video, Power, and Data Balun Installation Manual  Transmits up to 1,300ft (400m) color video or up to 1,950ft (600m) B/W video  Transmits power for 12/24 VAC/VDC cameras (see pg.
PAGE 2
ENFORCER Passive Video, Power, and Data Balun Specifications: B/W Color Other Connections Video Range* Video format Maximum input Insertion loss Return loss Frequency response Common mode rejection Wire type Wire category Video in Camera side Power out Data out Video out Cable side Power in Data in BNC Connection Attenuation Coax, male BNC Impedence RJ45 Max.
PAGE 3
ENFORCER Passive Video, Power, and Data Balun Installation: IMPORTANT: If using a balun to run power, make sure the terminals are connected to power at both ends. Connecting a power supply to a camera’s data will cause damage to the camera. Double-check all connections before powering the units. 1. Video baluns are connected in pairs. Connect one balun to the CCTV camera. Connect another balun to a DVR or other remote device. 2.
PAGE 4
ENFORCER Passive Video, Power, and Data Balun Troubleshooting: Wavy or ghost image if connected to image processor (e.g., multiplexer or DVR), but not if directly to monitor. Image background flutters between dark and light. Image is wavy and shakes. Image is weak or faded. No image. PTZ Controls do not work. Overload/overcurrent status LED is ON. Power LED is OFF  Move the Cat5e/6 cable away from possible sources of interference.