User Manual

ENFORCER VPD Combiners
6 SECO-LARM U.S.A., Inc.
Installation:
1. Location: Install the unit in a ventilated, dry location where it will not be disturbed by other
activities. A data center room is ideal.
NOTE: For indoor use only. Make sure there is a cool air flow around the unit to prevent it from
overheating.
a. Install the Passive Midpoint VPD Combiners near the power supply at a point between
the cameras and DVR.
b. Install the Active Midpoint VPD Combiners at a point between the cameras and DVR. A
power supply is already included in these models.
c. Install the Passive Endpoint VPD Combiners near the power supply and DVR – ideally in
the same room.
d. Install the Active Endpoint VPD Combiners near the DVR – ideally in the same room. A
power supply is already included in these models.
2. Mounting:
a. Wall-mounting – attach the two included mounting brackets to the sides of the VPD
Combiner (see fig. 1). Then attach to a wall with the four included screws and, if needed,
optional screw anchors.
b. Rack-mounting – attach the two included mounting brackets to the front or back of the VPD
Combiner (see fig. 2). Then attach to a standard 19” rack with the four included screws.
NOTE: Rack-mounting is available for 16-channel models only.
Fig. 2 (Rack-Mounting)
Fig. 1 (Wall/Desk-Mounting)