User Manual

ENFORCER VPD Combiners
10 SECO-LARM U.S.A., Inc.
Wiring the Passive Endpoint VPD Combiners
(EB-P304-01EQ, EB-P316-60EQ):
1. Connect cameras to VPD baluns (such as the EB-P101-20VQ) and run them via CAT5e/6 to
the “Camera” ports on the VPD Combiner.
2. Run 12 or 24 VDC power to the “Power In” press-fit terminals on the VPD Combiner, depending
on each camera’s power requirements. For each camera port connected to the VPD balun, the
corresponding power input must be connected to power.
NOTE: Observe polarity when connecting power.
3. Run coaxial cables from the BNC ports on the VPD Combiner to the BNC ports on the DVR.
4. Run a CAT5e/6 cable from the “Data Out” port on the VPD Combiner to the DVR or PTZ
Controller.
Sample Installation:
NOTE: EB-P304-01EQ shown. EB-P316-60EQ has similar connections, but has 16 channels.
Power for
Camera 1
Power for
Camera 2
Power for
Camera 3
Power for
Camera 4
Video
Power
Video
Video
Data and
Power
Power
Video
Power
Cat5e/6
Cat5e/6
Cat5e/6
Cat5e/6
ENFORCER Passive 4-Channel
End-Point VPD Combiner
ENFORCER
Passive VPD Balun
ENFORCER Passive
Baluns with Power or
Data Pass-Through
Cat5e/6 (Data)
Video
ENFORCER
H.264 Network DVR
Monitor
Coax (Video)
Can Use Any
External Low Voltage
Power Supply