User Manual

ENFORCER Passive Video Baluns
4 SECO-LARM U.S.A., Inc.
Wavy or ghost image if connected to image
processor (e.g., multiplexer or DVR), but not if
directly to monitor.
 Move the Cat5e/6 cable away from possible sources of interference.
 Ensure that the same twisted pair connects to a balun at both ends of the cable.
 Replace the cable with a new Cat5e/6 cable.
Image background flutters between dark and
light.
 Remove a local power source, or adjust the monitor’s brightness and contrast.
Image is wavy and shakes.
 Try reversing polarity of the two wires at one end of the Cat5e/6 cable.
Image is weak or faded.
 Reduce the Cat5e/6 cable length.
 Replace with a higher-grade cable. Cat5e cable meets the specifications in the
manual. Cat6 cable allows longer range.
No image.
 Double-check that the Cat5e/6 and BNC cables are connected properly.
 Run a continuity test on all wires in the cable.
 Check that the camera and monitor are powered up.
MiEB-P101-xxQ_1211.docx
PICFN1
IMPORTANT
Users and installers of this product are responsible for ensuring this product complies with all national, state, and local laws and statutes related to monitoring and
recording audio and video signals. SECO-LARM will not be held responsible for the use of this product in violation of any current laws or statutes.
WARNING
Incorrect mounting which leads to exposure to rain or moisture inside the enclosure could cause a dangerous electric shock, damage the device, and void the
warranty. Do not open the case of this device, as there are no field-serviceable components inside.
NOTICE
The information and specifications printed in this manual are current at the time of publication. However, the SECO-LARM policy is one of continual development and
improvement. For this reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints or
typographical errors.
Copyright © 2012 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or in part, without the written permission of
SECO-LARM.
SECO-LARM U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Tel: [phone] Fax: [phone]
Website: www.seco-larm.com
E-mail: [e-mail]
Troubleshooting:
WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for two (2) years from the date of sale
to the original customer. SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to
SECO-LARM. This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration, improper or
abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes other than
defects in material and workmanship. The sole obligation of SECO-LARM and the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at
SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property damage of any kind to the
purchaser or anyone else.
Also Available from SECO-LARM:
4-Channel Passive
Video Transceiver
16-Channel Passive
Video Transceiver
Active Video Baluns
(Single or Hub)
Passive Video, Power,
and Data Balun
Weatherproof Passive
Video Balun
Passive Video Balun with
Ground Loop Isolator