User Manual

ENFORCER Passive Video Baluns
SECO-LARM U.S.A., Inc. 3
Installation:
1. Video baluns are connected in pairs. Connect one balun to the CCTV camera. Connect
another balun to a DVR or other remote device.
2. Make sure the distance between the camera and the remote video device does not exceed
1,950ft (600m) for black and white video or 1,300ft (400m) for color video.
3. Run Cat5e/6 cable (UTP) from the remote video device to the camera.
4. Connect the Cat5e/6 cable to both baluns. NOTE: Video baluns are polarity-sensitive.
a. Strip approximately
1
/
4
” (6mm) of insulation from the same two wires at both ends of a
Cat5e/6 cable.
b. Push down the small tabs above the terminals. Insert each wire into each terminal at both
ends of the cable. After the wires have been inserted into the terminals, there should be no
bare wire showing.
5. Connect the video baluns into the BNC connector of the CCTV camera and the remote
video device.
6. Test the connection by powering up the CCTV camera and remote video device to make sure
they operate as expected.
Sample Applications:
Single Pair of Passive Video Baluns
ENFORCER
Bullet Camera
Cat5e/6 Cable
Color: Up to 1,300ft (400m)
B/W: Up to 1,950ft (600m)
1
/
4
” (6mm)
Leave no
wires exposed
Remote
DVR, Monitor, Switch, etc.
Note: Shorter range may result when used with a DVR.
Multiple CCTV Cameras Over a Single Cat5e/6 Cable
Cat5e/6 Cable
Color: Up to 1,300ft (400m)
B/W: Up to 1,950ft (600m)
ENFORCER
Bullet Camera
Passive Video Baluns
connected to a DVR
ENFORCER
Dome Camera
Elite 3X
Dome Camera
Elite 3X
Bullet Camera
Small size allows
multiple baluns to
be mounted to the
back of a DVR.
Note: Shorter range may result when used with a DVR.