User Manual

ENFORCER VPD Combiners
8 SECO-LARM U.S.A., Inc.
Wiring the Passive Midpoint VPD Combiners
(EB-P304-01MQ and EB-P316-60MQ):
1. Connect cameras to VPD baluns (such as the EB-P101-20VQ) and run them via CAT5e/6 to
the “Camera” ports on the VPD Combiner.
2. Run 12 or 24 VDC power to the “Power In” press-fit terminals on the VPD Combiner,
depending on each camera’s power requirements. For each camera port connected to the VPD
balun, the corresponding power input must be connected to power.
NOTE: Observe polarity when connecting power.
3. Run a CAT5e/6 cable from the “Video Out” port on the VPD Combiner to baluns or a multiple-
channel passive video transceiver on the DVR side.
NOTE: Consult the balun or video transceiver manual for range information.
4. Run a CAT5e/6 cable from the “Data Out” port on the VPD Combiner to the DVR or PTZ
Controller.
Sample Installation:
NOTE: EB-P304-01MQ shown. EB-P316-60MQ has similar connections, but has 16 channels.
Video
ENFORCER
Passive Video
Transceiver
Power
Video
Video
Data and
Power
Power
Video
Power
Cat5e/6
Cat5e/6
Cat5e/6
Cat5e/6
Cat5e/6 (Video)
Cat5e/6 (Data)
Video
Video
ENFORCER
H.264 Network DVR
ENFORCER Passive 4-Channel
Midpoint VPD Combiner
ENFORCER
Passive VPD Balun
ENFORCER Passive
Baluns with Power or
Data Pass-Through
Monitor
Power for
Camera 1
Power for
Camera 2
Power for
Camera 3
Power for
Camera 4
Or RJ45
Can Use Any
External Low Voltage
Power Supply