User Manual

ENFORCER Curtain Sensors
6 SECO-LARM U.S.A., Inc.
For best results when the curtain sensor is mounted outdoors, remove the transmitter lens caps
(DO NOT remove the receiver lens caps!).
To remove the lens caps (see Fig. 8):
1. Slide the PCB out of the transmitter (see
“Connecting the Wires” on pg. 5~6).
2. Carefully pull the lens cap off of all the lenses
(4 for the E-9611-2x25, 8 for the E-9622-4x25,
12 for the E-9644-6x25, 16 for the E-9660-8B25, 20 for the E-9680-10B25).
3. Slide the PCB back in (see “Connecting the Wires” on pg. 5~6).
2. Transmitter:
a. Pull the end cap with the red wire leads off the transmitter, and slide the PCB out far
enough to expose the wiring block.
b. Run the two power wires through one or more of the three round knockout holes in the end
cap near where the tamper button wires run; connect them to the wiring block (see Fig. 7).
c. Program the transmitter (see Table 2 below).
d. Carefully push the PCB back into the case and reinsert the end cap.
e. Reinsert the cap over the tamper button and small tamper cap.
Note:
1. Screw the wires tightly to avoid slipping off the terminals, but not so tight that they break.
2. Unused terminal screws should be tightened.
3. Grounding may be necessary, depending on the location.
Fig. 8: Removing the Lens Caps
Connecting the Wires, continued:
*Both JMP2 and SA1 should be taken off or left on at the same time.
Removing the Lens Caps (for outdoor use only):
Table 2: Transmitter and Receiver Programming
Receiver
Transmitter
Jumper name
JMP1
JMP0
LED Operation
1 C 2

LED ON if power is
present and beams
are aligned.

LED flashes when
beams are broken.
1 C 2

LED OFF if power is
present and beams
are aligned.

LED flashes when
beams are broken.
LED ON

LED ON if power
is present.
LED OFF

LED OFF at
all times.
Jumper name
JMP2
SA1
Number of beams
to interrupt to
trigger transmitter
and receiver
1 Beam
Receiver triggers if
any single beam is
interrupted.*
2 Beams
Receiver triggers
only if 2 adjacent
beams interrupted
at same time.*
1 Beam
Transmitter
triggers if any
single beam is
interrupted.*
2 Beams
Transmitter triggers
only if 2 adjacent
beams interrupted at
same time.*