MANUAL SD-8202GT-PEQ SD-8103GT-PEQ Wireless Request-to-Exit Plates SD-8202GT-PEQ SD-8103GT-PEQ NOTE: Products with a model number that ends with “Q” or have a round green “Q” sticker represent RoHs compliant products.
ENFORCER Wireless Request-to-Exit Plates Introduction: The ENFORCER Wireless RF Request-to-Exit Buttons are the ideal solution for difficult Access Control installations. The RTE plates combine the very best of SECO-LARM, flexible wireless solutions and reliable access control. The RTE plates are perfect for cement or brick walls, or any other location where it is difficult to run wires. Features: Built-in RF transmitter: - Powered by 9VDC (battery included). - Range up to 250 feet. 315MHz.
ENFORCER Wireless Request-to-Exit Plates Installation: 1. Find a suitable location for the wireless request-to-exit plate. NOTE: Do not house the plate in a metal box, this will greatly reduce the range. 2. The wireless request-to-exit plate can be either surface mounted or flush mounted. 3. Test the operation of the wireless request-to-exit plate in the location where it will be installed. NOTE: The wireless request-to-exit plate first needs to programmed into the SK-910R receiver before testing.
ENFORCER Wireless Request-to-Exit Plates Troubleshooting: LED is red LED does not light 9V battery is low, replace with new one Check battery connection Replace 9V battery LED lights blue, but does not activate lock Check to make sure wireless request-to-exit plate is not housed in a metal box Test wireless request-to-exit plate closer to the receiver Clear codes from receiver, and re-learn wireless plate transmitter code Also Available from SECO-LARM: Handheld Transmitters Desktop RF Transmitters W
