User Manual
Table Of Contents
- Models 728-738-752
- II Installation
- 2.1 Mounting
- 2.2 Connections
- Figure 1 Figure 1A
- Series 700HS units are gasket-sealed. Changes or adjustments to the operating modes of any unit are accomplished internally:
- 1) To gain access, (Disconnect power from the unit before opening) remove the 5 outer black hexagonal head screws retaining the connector plate as shown in Figure #4. Then remove the 4 screws surrounding the connector. This will enable the removal of ...
- 2) After removing the screws, lift the panel to expose the internal components as shown. Figure#5 shows the adjustments and their locations
- Figure 1 Figure 1A
- 728 HS Specifications Manual
- 738 HS Specifications Manual
- 752 HS Specifications Manual
- Models 728-738-752
3) Restore the front plate to its original position by replacing the (4) connector securing screws
and then the (5) front plate hex head screws making sure the gasket is compressed.
IV Warranty and Repair
Should your investigations indicate that your product is defective or damaged and the unit is still
under warranty, contact your dealer (purchase point of origin) and obtain a return merchandise
authorization (RMA number) for corrective action.
If the warranty period has expired or if the warranty has been violated due to operator error or misuse
call: SEC America Corp. 802-865-8388 to receive an authorization for return for an assessment and
possible repair.
Warranty
700HS Series models come with a 2-year factory warranty covering parts and labor per the
following:
We warrant each instrument, sold by us, or our authorized agents, to be
free from defects in material and workmanship and that it will perform
within applicable specifications for a period of two year after original
shipment. Our obligation under this guarantee is limited to repairing or
replacing any instrument or any part thereof,except fuses and pilot lights,
which shall within one year after delivery to the original purchaser, be
returned to us with transportation charges prepaid, prove after our exa-
mination to be thus defective.
LIMITED WARRANTY
The above limited warranties take the place of all other warranties,
expressed or implied, and correction of such defects by replacement or
repair shall constitute a fulfillment of all obligations under the terms of the
warranties. The warranties do not cover any unit that has been damaged
either in transit or by misuse, accident or negligence. No warranty or re-
presentation by anyone other than this Company shall be binding on us.
To return a unit to factory, send only to the following address:
SEC America Corp.
78 Ethan Allen Drive
South Burlington, Vermont 05403
PLEASE RETAIN YOUR ORIGINAL BILL OF SALE. IT MUST
BE SUBMITTED WHEN MAKING ANY WARRANTY CLAIM
Tel: 802-865-8388
Page 4