Owner`s manual

ManualsBrandsSebo ManualsHousehold AppliancesFelix IceBlue

VACUUM MAINTENANCE

Changing the Filter Bag - Figures 17 & 18

To change the filter bag, set the canister upright, open the filter bag

cover (8) by pulling the cover release flap (10) upward (figure 17).

Seal the filter bag with the sealing cap (42). Grasp the sealing plate

(44) of the filter bag with your thumb and forefinger as shown in fig-

ure 18 and lift the filter bag (43) out. Lower a new bag into the hold-

er, making sure that the 4 small tabs (indicated by arrows on the

sealing plate) fit into the appropriate grooves. The front tab (45) of

the sealing plate will fit loosely over the wire latch lock. Push the

filter bag cover (8) down firmly and snap the cover release flap (10)

into place. For your convenience, there is a diagram on every filter

bag showing the correct placement of the bag. Do not re-use the

filter bags. NOTE: the nature of the contents of the filter bag will

affect the point at which it needs changing. Fine dust may require

an earlier change even though the bag is not full. Fluff or hair allows

air to pass through easily, so the filter bag may overfill before the

orange “bag full” indicator displays.

Changing the Exhaust Filter - Figures 19 & 20

The exhaust filter (12) needs to be changed when it becomes

extremely dirty or clogged with dust, or after approximately 10 to

20 filter bags have been used. To remove the exhaust filter, set the

vacuum upright, and remove the filter retaining rings (13). To

release the filter retaining ring, use your thumb to push the retain-

ing ring clip the direction of the arrow, then pull the clip up. Pull the

reinforced strips out of the housing slot (48), and remove the filter.

To replace the filter, insert the reinforced strip on one end of the fil-

ter into the housing slot (48) and hold in place with one hand while

wrapping the filter around the machine, pulling it taught. While

holding the filter together, insert the top of the reinforced strip into

the slot. While holding the top of the strip in place, push the rest of

the strip firmly into the slot. Replace the retaining rings. NOTE:

when reassembling, please ensure that the exhaust filter is fitted

correctly in the housing slots and the filter retaining rings are

installed correctly. Otherwise, the filter will be ineffective.

Figure 18

Figure 20

Figure 19

Always unplug vacuum from outlet

before dismantling any part of machine!

Changing the Motor Protection Filter - Figure 19

After 10 to 20 bags have been used, change the motor protection

filter (46). To remove the micro-hygiene filter, set the vacuum

upright, pull the cover release flap (10) outward and open the fil-

ter bag cover (8). Remove the filter bag (see above). Grasp the

handle (47) on the filter and pull it out. To replace, use the handle

(47) to hold on to and slide the new filter down into the bottom of

the filter bag housing. When correctly seated, it will snap into

place. Insert the filter bag, close the filter bag cover.

Figure 16

Note: Never operate the vacuum with incorrectly attached filters or without filters, filter bag, or filter bag housing

cover (8). Do not re-use filter bags. Do not wash and re-use filters.

4243

Figure 17

Filter bag

Part # 7029 ER

Motor protection

filter

Part # 7012 ER

Exhaust filter

Part #:

7095 ER 01 - Fun

7095 ER 02 - Ice Blue

7095 ER 03 - Classic

7095 ER 08 - Dark Blue

When the “bag full” indicator (7) displays, airflow is reduced due to

a full filter bag, dirty filters, or a clog. If the filter bag is empty and

the filters are clean, you may have a clog. Refer to page 10.