Owner`s manual

ET POWER HEAD MAINTENANCE
8
To remove a brush or floor tool, switch off the power and unplug the
vacuum. Then, press the tool release button (14) and pull the vacuum out of the
neck.
Premium Parquet Brush - Figure 13
The Premium parquet brush is specially designed for use on hard surfaces. The
brush should be cleaned regularly. Remove the parquet brush from the vacuum to
clean. Fibers and hair can be pulled out of the bristles manually, or vacuum the
bristles using the flexible hose.
Kombi Nozzle - Figure 14
The Kombi nozzle is adjustable for carpet or hard floors. To set for carpet, slide the
up arrow button (39) to the right until it clicks into place. The hard floor dusting
brush will raise up allowing the head to move over the carpet. To set for hard floors,
slide the down arrow button (40) to the left until it clicks into place. The brush will
lower to gently sweep your floors. The slider in Figure 14 is set in the position for
carpet. The brush should be cleaned regularly. Remove the Kombi nozzle from the
vacuum to clean. Fibers and hair can be pulled out of the bristles manually, or vac-
uum the bristles using the flexible hose.
Turbo Head - Figure 15
The Turbo head has an air-driven rotating brush for gentle brushing of carpets. The
Turbo head can be adjusted for high and low pile carpet. To adjust the head for high
pile carpet, push the slider button (41) to the right. For low pile carpet, push the slid-
er button (41) to the left. The slider in Figure 15 is set in the high pile position. The
rotating brush should be cleaned regularly. Remove the Turbo head from the vacu-
um to clean. Remove fibers and hair from the brush manually or vacuum using the
flexible hose.
Figure 13
Figure 15
Figure 14
40
▲
▲
Always unplug vacuum from outlet before
dismantling any part of machine!
!
USE AND MAINTENANCE OF FLOOR TOOLS AND BRUSHES
39
41
▲
▲
▲
▲
To remove the power head, switch off the power and unplug the
vacuum. Then, press the tool release button (12) and pull the vacuum
out of the swivel neck.
Removing the Brush Roller - Figure 12
To remove the brush roller, press the button marked “PRESS” (36) and
turn the brush roller end cap (37) downward. Turn the brush (38) slight-
ly to the right and pull it out. We recommend regular removal of threads
and hair which have wound around the brush roller.
Cleaning the Brush Roller
Unplug the vacuum before attempting to clean the brush.
The brush should be cleaned regularly. Fibers and hair can be pulled out
of the brush while manually rotating the roller, or the roller can be
removed from the power head to clean it.
Always unplug vacuum from outlet before dismantling any part of the machine!
!
Figure 12
36
37
38
12” Brush roller
Part # 5010 AM
15” Brush roller
Part # 2838 AM