Owner`s manual

12
ADDITIONAL TROUBLE-SHOOTING GUIDE FOR ET POWER HEADS
PROBLEM
Does not turn on
Amber and green lights
are both on
No lights are
illuminated
Amber light is on &
brush stops spinning
Does not pick up
REASON
1. The switch on the power head
is off.
2. The internal switch in the
swivel neck is off because the
machine is in the upright locked
position.
1. Brush worn.
2. Reduced brush action.
1. Machine is in upright locked
position and roller is shut off.
2. The switch on the power head
is off.
3. The internal switch in the
swivel neck is off because the
machine is in the upright locked
position.
1. Jammed brush roller.
2. Clog in airflow pathway or
swivel neck.
3. Overload shut down from
excessively deep but loose
carpet pile (e.g., long shag
carpet).
1. Flexible hose not inserted properly
into vacuum.
2. Brush roller has hair or debris
wrapped around it.
SOLUTION
1. Press the power head brush
on/off switch. See page 7.
2. Release the foot pedal and
lower the telescopic tube to
operating level. See page 7.
1. Replace brush. See page 8.
2. Brush is not fully in contact
with the floor.
1. Release the foot pedal and
lower the vacuum to operating
level. See page 7.
2. Press the power head brush
on/off switch. See page 7.
3. Release the foot pedal and
lower the vacuum to operating
level. See page 7.
1. Remove brush roller
obstruction. See page 8.
2. Remove clog. See page 8.
3. If carpet pile is too deep and
loose, then use a “shag rake”
attachment instead of the
ET-1 or ET-2 power head.
1. See page 5.
2. Clean brush roller. See page 8.
Always unplug vacuum from outlet before dismantling any part of the machine!
!