Specifications

The DISCO Polisher is the solution to all of these problems,
and it is built to commercial-quality standards!
Pads*
Usually, maintaining the shine of hard floors is difficult,
due to the following problems:
S
mall and medium-size, furnished, hard-floor areas
do not easily accommodate typical polishers.
Big, heavy, hard-floor polishing machines are difficult
to use, require trained staff and are expensive.
Regular maintenance of hard floors is costly and time
consuming.
Typical hard-floor polishers have limited flexibility
and mobility.
Most hard-floor polishers cannot reach small areas.
Correct use of floor-care chemicals and polishing
sands is difficult and requires sophisticated
knowledge.
The DISCO Floor Polisher – introduces a new sophisticated and
highly efficient floor-pad technology that produces a high-gloss
effect without the use of water, chemicals or polishing sands.
T
he new technology achieves its results by using four different
floor pads, each of which is designed to accomplish distinctly
different tasks. The pads are color-coded to assure proper
selection. In addition, they are highly abrasion resistant and
h
ave a life expectancy of over 100,000 square feet.
The DISCO is usually suitable for the following types of floors:
PVC (coated or uncoated vinyl or vinyl composite tiles).
Natural stone, such as granite, marble or terrazzo.
Acrylic or polyurethane-coated floors.
Hardwood with oil or varnish finishes.
Hardwood or other floors with soft-coated finishes, like
wax (use the blue floor pad only).
The Red, Yellow and Green Floor Pads – restore the shine of
dull, scratched and scuffed, hard-floor surfaces without the use
of water, chemicals or polishing sands. The pads do the work
using the following three-step procedure (soft coatings should
not be present):
Step One. The Red Floor Pad – removes the deepest or
most visible scratches and smoothes the floor surface.
Thus, it prepares the floor for the yellow pad.
Step Two. The Yellow Floor Pad – restores a higher
gloss finish and prepares the floor surface for the
green pad.
Step Three. The Green Floor Pad – creates the final
gloss finish in the “three-step process,” and it is
suitable for daily use to maintain the floor’s high-
gloss finish.
The Blue Floor Pad – is designed to maintain soft coatings,
like wax, on hard floors, and it is suitable for daily use as well.
It should be used along with a typical floor wax suitable for
the specific floor surface or recommended by the flooring
manufacturer. And because the DISCO has suction ability
while polishing, it removes the fine dust from fully dried
floor-wax products.
* PLEASE NOTE: Suitability of all floor surfaces should
first be determined by consulting the manufacturer
recommendations, and then by testing the DISCO and its
four pads in an inconspicuous spot. If floor damage occurs,
immediately discontinue use.
The DISCO is NOT suitable for the following types of floors:
Any floor on which a shiny finish is not desired.
Glazed, ceramic and porcelain tiles, or porous tiles such
as terracotta or slate.
Cushioned vinyl, linoleum, laminate, and any floor types
that are poorly bonded to the sub-floor.
All floors with textured or uneven surfaces or tiles with
raised edges.
Floors with maintenance-free coatings, floors in which
acceptability of the polisher is uncertain, or when
polisher use is contrary to manufacturer
recommendations.
15
l
l
l
l
l
l
l
l
l
l
l
l
l
l
Green Pad
#3230ER30
R
ed Pad Yellow Pad
B
lue Pad
#
3230ER00
#3286ER40
R
ed and Yellow Pads in one box.
Step One Step Two
Step Three
Included with DISCO
Floor Polisher
l
l
l
l
l
Original Step One: The Red Floor Pad
Step Two: The Yellow Floor Pad Step Three: The Green Floor Pad