User Manual

Required radio, motor and battery
Radio equipment:
• Minimum 6-channel radio system
• 5 digital servo: 3 JR DS 9511 or DS 9401 (ailerons and rudder) + 2 JR DS 3201 (elevators)
• 2 servo extensions 900mm, for elevator’s servos
• 1 extension 500mm, for rudder servo
Recommended electric motor for best performance:
• Hacker A50-16S + Jeti Master Basic 70A SBec + APC 16 x 12E or 17x8E
• Battery pack Top Fuel 4000-6S or 4500-6S
Additional required item, tools and adhesives
Tools:
• Drill
• Drill bits: 1,5mm; 2mm; 2,5mm; 3mm
• Phillips screwdriver
• Hobby knife
• Masking tape
• Paper towels
• Rubbing alcohol
• Sand paper
• Soldering iron
• synthetic oil
Adhesives:
• 5-minute epoxy
• thin CA
• medium CA
Warning
This RC aircraft is not a toy!
If misused, it can cause serious bodily harm and damage to property.
Fly only in open areas, preferably in official flying sites, following all instructions included with
your radio and motor.
This plane is a compromise between Aerobatics and 3D flying, and not a pylon racer.
It is built with a very light structure and for this reason we hardly recommend:
→ Do NOT fly your airplane at high speeds
, because this may cause structural
failures or flutter due to the extremely large control surfaces.