User Manual

26
Rates and expos
Use the recommended expos to soften the feel of the model, expecially on high 3D rates. The goal
is to get the model to feel the same around neutral as it does on low rates.
Use low rate settings for all flying, included starts and landings, and high rate for 3D aerobatics.
For precision flying or general sport fliers, the low rate throws are perfect, even for snap rolls.
When doing 3D aerobatics, flip to 3D rates just before the manouer. As soon as the manouver is
done, flip back down to low rate to avoid over-controlling the model.
Recommended CG
The recommended Center of Gravity location is 125mm behind the leading edge of
the wing against the fuselage.
 120mm is good for pattern flying.
 130mm is good for 3D flying.
Use the Flight Power battery pack, moving it forward or backward, to achieve the correct balance.
Range test your radio


 step 1
Before fly, be sure to range check your radio as manufacturer’s instruction manual of you radio-
system recommand.


 step 2
Double-check all controls (aileron,elevator, rudder and throttle) move in the correct direction.


 s
tep 3
Be sure that your Flight Power batteries are fully charged, as per the instructions and that your
radio is fully charged as per its instructions.
Finally...
Finally... Finally...
Finally...
have a nice flight!
have a nice flight! have a nice flight!
have a nice flight!
SebArt di Sebastiano Silvestri
Via Roma 83/85
38017 Mezzolombardo (TN) – Italy
www.sebart.it