User Manual

Required radio, motor and battery

Radio equipment:

• 6-channel radio system

• 4 digital mini servo for ailerons, recommended JR PROPO DS385 or DS381

• 2 digital standard servos, recommended JR PROPO DS 9401

• 2 servo extension 300mm, for rudder and elevator servos

• 4 servo extension 100mm, for aileron servos

• 2 “Y” leads for aileron servos

Recommended electric motor for best performance:

• Hacker A50-16S + Master Basic 70 S-BEC + APC 17x8E

Recommended Li-Po battery pack for best performance:

• FlightPower 3700mAh 6S.….for unlimited 3D

• FlightPower 4250mAh 6S…..for 3D, duration and precision

Additional required item, tools and adhesives

Tools:

• Drill

• Drill bits: 1,5mm; 2mm; 2,5mm; 3mm

• Phillips screwdriver large and small

• Hobby knife

• Sand paper

• Soldering iron

Adhesives:

• 5-minute epoxy

• thin CA

• medium CA

Warning

This RC aircraft is not a toy!

If misused, it can cause serious bodily harm and damage to property.

Fly only in open areas, preferably in official flying sites, following all instructions included with

your radio and motor.

This plane is a compromise between Aerobatics and 3D flying, and not a pylon racer.

It is built with a very light structure and for this reason we hardly recommend:

→ Do NOT fly your airplane at high speeds, because this may cause structural

failures or flutter due to the extremely large control surfaces.