User's Manual

LOG DX / TDM 200
73
► In the second list, select the device to be updated.
► Tap Install.
The update begins!
NOTE
Do not interrupt the process. Do not make any entries until the update is complete.
The connection between PocketServer and device is established. The firmware data is
transmitted. The wireless LED of the PocketServer lights up blue. The status LED on the
device lights up blue/white. Progress of the procedure is displayed on the screen.
If an error occurs (error message), the process must be restarted.
After successful data transfer, the new firmware is installed on the device. The status
LED on the device lights up red. The device is then restarted.
The firmware update is now complete.
If you read out the configuration of the device, under Device info, the new firmware
version is displayed.
To safely remove the USB stick from the PocketServer, proceed as follows:
► Tap the button .
► Tap USB.
► Tap Remove USB device.
You can now remove the USB stick.
Safely removing the
USB device