User's Manual

LOG DX / TDM 200
68
► In the PocketServer start screen, tap LOG DX / TDM 200.
► Select the desired device from the Devices list.
► Tap the button .
► In the context menu, tap GPS.
The GPS coordinates of the mobile device are determined and displayed in a dialogue
window. This may take some time. Tap OK to confirm and to save the displayed data in
the PocketServer for the respective device.
If no coordinates can be determined, an error message appears.
7.10 Programming
INFO
The function ‘Programming devices’ does not belong to the PocketServer basic
equipment. It is only available after acquisition and input of a license key in the device.
To program a logger/device, proceed as follows:
► In the start screen, tap LOG DX / TDM 200.
► Select the desired device from the Devices list.
► Tap Program.
On the screen, you will find the Measurement settings and GSM settings drop-
down menus. There all adjustable parameters are compiled.
► You may be prompted to read out the current programming of the device now. In this
case, tap on the additionally available button Read.
The connection to the device is established and the data is received by the
PocketServer.
► Enter the desired settings.
 Comment
Here you can enter the general information on the device, installation site, etc.
 Storage
Activate/deactivate the ring storage function for the data storage of the logger/device.
 Interval
Select the measurement interval
Channel 1 to Channel 4 drop-down menus
You can find the measuring channel specific settings here:
 Channel active
Activate/deactivate the measuring channel for the measurement.
A deactivated channel does not participate in the measurement. All sensor settings
are then hidden.
Measurement settings