User's Manual

LOG DX / TDM 200

► Tap the Play button in the top left to resume the stopped measurement.

With the checkbox Val., a small table can be shown/hidden. This contains the current

measurement interval and the last measured value of each measuring channel. You can

touch and drag this table on the screen.

You can hide curves from the diagram. To do so, tap on the corresponding coloured

rectangles below the diagram.

You can narrow the time range (zoom function). To do so, mark the desired area in the

diagram with your finger or move the two controls at the top in the diagram. Tip ‘Show

all’ to reset.

You can display the values of each individual recording. To do so, touch the desired

point on a curve. A vertical red line appears. The level, frequency and time of the

recording can be read off there.

(These functions are also explained in the section Displaying measurement data.)

In the system settings of the PocketServer, you can specify how many values will be

displayed in the diagram.

► If a real-time measurement is running, interrupt it with the Stop key .

► Tap the button to go the system settings.

► Tap Settings.

► Tap Realtime view.

► Select the desired number from the drop-down list.

Example: If you select the option Show all, each new measurement will be added to

the diagram. All values of the previous measurement can be seen in the diagram.

If you select the option 10 values, only the last 10 measurements are always

displayed in the diagram. When each new recording is added, the oldest recording

disappears from the view.

► Confirm with OK.

► With the button, you can return to the real-time measurement. The connection

between PocketServer and the device is immediately re-established and the real-time

measurement is restarted.

7.9 GPS position

You can determine and store the GPS data for the location of a logger/device.

Requirements:

 Your mobile device (smartphone or tablet etc.) must be GPS-capable.

 The GPS function of your mobile device must be activated (location services

activated).

Procedure:

► Go to the installation location of the device with your mobile device.

Editing a diagram

Changing the number

of displayed values