User's Manual

LOG DX / TDM 200
65
 Interval
Currently set measurement interval
 The Channel 1 to Channel 4 drop-down menus show which measurement channels
are activated and which sensor settings have been made.
 The Alarm input 1 and Alarm input 2 drop-down menus show whether alarm-
triggering devices are connected.
GSM active indicates whether or not the GSM function of the device is activated.
Below are the GSM settings that were made when programming the device.
After closing the configuration data display, you will find this data record as a new entry
under Data. It can be accessed and displayed again there at any time.
7.5 Reading out pressure shocks
When reading the measured data, the pressure shock recordings are not transferred.
These records must be requested by the logger/device separately.
► In the start screen, tap LOG DX / TDM 200.
► Select the desired device from the Devices list.
► Tap Pressure shocks.
The connection to the device is established. The data is received by the PocketServer
and displayed on the screen.
In the diagram, the 60-second recording is shown as a curve.
In the field below the diagram, the date and time of the pressure shock are shown.
► Tap this field to open a list of all pressure shock recordings.
(If no list appears, no further recordings are present.)
► In the list, tap on a pressure shock to open it in the diagram.
After closing the pressure shock display, you will find this data record as a new entry
under Data. It can be accessed and displayed again there at any time.
7.6 Reading out night values
This function reads the lowest and the highest reading of the previous night* from the
logger/device.
► In the start screen, tap LOG DX / TDM 200.
► Select the desired device from the Devices list.
► Tap Night data.
The connection to the device is established. The data is received by the PocketServer
and displayed on the screen.
Measurement settings
GSM settings