User's Manual

LOG DX / TDM 200
62
► In the Devices section, select the corresponding device.
► Answer the confirmation prompt with OK.
The device disappears from the device list. All data of the device are deleted from the
PocketServer.
► Tap the button .
7.2 Reading the measured data
To read out the measured data from the device, proceed as follows:
► In the start screen, tap LOG DX / TDM 200.
► Select the desired device from the Devices list.
► Tap Measurement data.
► Decide whether All data or New data only will be read out.
‘New data only’ means: Only the measurement data that has been recorded since the
last reading are read out.
‘All data’ means: All measured data saved in the logger is read out.
The connection to the device is established. The data is received by the PocketServer
and displayed on the screen.
After closing the measurement data display, you will find this data record as a new entry
under Data. It can be accessed and displayed there at any time.
7.3 Displaying measurement data
Read-out measured data is saved in the PocketServer.
To access a measurement record, proceed as follows:
► In the start screen, tap LOG DX / TDM 200.
► Select the desired device from the Devices list.
► Select the desired measured data from the Data list.
The measurement data display opens:
X-axis … course of measurement over time
Y-axis … measurements