User's Manual

LOG D-3 / SebaFlow / TDM 300
60
The following is needed:
 Computer with USB interface and internet access
 A USB stick
Proceed as follows:
► Visit www.sebakmt.com and search for the current firmware for the corresponding
device type.
► Download the firmware to the computer. If it is a packed directory with the extension
.zip, unpack it. The name of the required firmware file ends with .ld3
► Connect the USB stick to the computer.
► Copy the firmware file to the main directory of the USB stick.
► Remove the USB stick from the computer (‘Safely remove hardware’).
► Connect the USB stick to the PocketServer.
► In the PocketServer user interface, tap the button.
► Tap Update.
► Tap LOG D-3 / SF / TDM 300.
A window opens with two drop-down lists.
► In the first list, select the firmware file.
► In the second list, select the device to be updated.
► Tap Install.
The update begins!
NOTE
Do not interrupt the process. Do not make any entries until the update is complete.
The connection between PocketServer and device is established. The firmware data is
transmitted. The wireless LED of the PocketServer lights up blue. The status LED on the
device lights up blue/white. Progress of the procedure is displayed on the screen.
If an error occurs (error message), the process must be restarted.
After successful data transfer, the new firmware is installed on the device. The status
LED on the device lights up red. The device is then restarted.
The firmware update is now complete.
If you read out the configuration of the device, under Device info, the new firmware
version is displayed.
To safely remove the USB stick from the PocketServer, proceed as follows:
► Tap the button .
► Tap USB.
► Tap Remove USB device.
You can now remove the USB stick.
Downloading
update files
Performing an update
Safely removing the
USB device