User's Manual

LOG D-3 / SebaFlow / TDM 300
59
6.11 Export data
You can connect a USB data store to the PocketServer and copy data from the
PocketServer to the USB stick. From the USB stick, the data can then be imported to
the SebaDataView-3 software.
► Connect the USB stick to the USB socket of the PocketServer.
► In the PocketServer start screen, tap LOG D-3 / SF / TDM 300.
To copy all data of all devices from the PocketServer to the USB stick (measured data,
configuration data, event data, etc.), proceed as follows:
► Tap the button .
► In the context menu, tap Export.
The data is transmitted. A success message appears at the end of the operation.
To copy all data of a specific device from the PocketServer to the USB stick (measured
data, configuration data, event data, etc.), proceed as follows:
► Select the desired device from the Devices list.
► Tap the button .
► In the context menu, tap Export.
The data is transmitted. A success message appears at the end of the operation.
To copy the measured data of an individual measurement from PocketServer to the
USB stick, proceed as follows:
► Select the desired device from the Devices list.
► Select the desired data record from the Data list.
► Tap the button .
► In the context menu, tap Export.
The data is transmitted. A success message appears at the end of the operation.
To safely remove the USB stick from the PocketServer, follow these steps:
► Tap the button .
► Tap USB.
► Tap Remove USB device.
You can now remove the USB stick.
6.12 Firmware update
SebaKMT provides regularly updated versions of the firmware at www.sebakmt.com for
all devices. Check and update regularly the firmware of your devices.
In order to determine which firmware version is currently installed on a device, read out
its configuration. The version is shown in the Device info section.
Option 1: Exporting all
data of all devices
Option 2: Exporting all
data of a device
Option 3: Exporting a
measurement
Safely removing the
USB device
Identifying the
firmware version