User's Manual

LOG D-3 / SebaFlow / TDM 300
51
A vertical red line appears (cursor). The time of the individual recording is displayed at
the base of the line. At the intersections with each curve, the measured value can be
read.
Metadata
You can display additional information about this data record.
► Tap the button .
► In the context menu, tap File info.
Above the diagram, a new area opens in which the data are listed.
► To hide, tap again on button and then on Hide info.
6.4 Reading out a configuration
To read out the current programming of the logger/device, proceed as follows:
► In the start screen, tap LOG D-3 / SF / TDM 300.
► Select the desired device from the Devices list.
► Tap Settings.
The connection to the device is established. The data is received from the
PocketServer.
On the screen, you will find the data in these drop-down menus:
 Firmware
Currently used firmware version of the device
 Battery
Battery level of the device (full/good/OK/poor)
 Time
Internal date and time of the device (at the readout time)
 Storage
Indicates whether or not the data storage of the device operates as a ‘ring storage’.
Device info