User's Manual

LOG P-3 / P-3 mini
43
► In the PocketServer start screen, tap LOG P-3/LOG P-3-mini.
► Select the desired logger from the Devices list.
► Tap Realtime.
The connection to the logger is established. The logger starts to measure. The recorded
values are received in real time by the PocketServer and displayed in a diagram as a
curve.
► Tap the Stop button in the top left to stop the current measurement.
The logger stops recording and transmitting data to the PocketServer. The diagram
view freezes. A dialogue window opens. Decide here whether you want to save the
data from this measurement to the PocketServer.
► Tap the Play button in the top left to resume the stopped measurement.
With the checkbox Val., a small table can be shown/hidden. This contains the current
measurement interval and the last measured value. You can touch and drag this table
on the screen.
You can narrow the time range (zoom function). To do so, mark the desired area in the
diagram with your finger or move the two controls at the top in the diagram. Tap ‘Show
all’ to reset.
You can display the value of each individual recording. To do so, touch the desired point
on the curve. A vertical red line appears. The value and time of the recording can be
read off there.
(These functions are also explained in the section Displaying measurement data.)
In the system settings of the PocketServer, you can specify how many values will be
displayed in the diagram.
► If a real-time measurement is running, interrupt it with the Stop button .
► Tap the button to go to the system settings.
► Tap Settings.
► Tap Realtime view.
► Select the desired number from the drop-down list.
Example: If you select the option Show all, each new recording will be added to the
diagram. All values of the running real-time measurement can be seen in the
diagram.
If you select the option 10 values, only the last 10 recordings are displayed in the
diagram. When each new recording is added, the oldest recording disappears from
the view.
► Confirm with OK.
► With the button, you can return to the real-time measurement. The connection
between PocketServer and the device is immediately re-established and the real-time
measurement is restarted.
Stopping/resuming a
measurement
Editing the diagram
Changing the number
of displayed values