User's Manual

LOG N-3
31
INFO
For detailed explanations of the individual settings, refer to the operating instructions of
the LOG N-3 system.
► Tap Send to program the logger group now, or tap Store if you want to program the
loggers at a later time.
For Send, the configuration of the PocketServer is transmitted to all loggers of the group
and applied there. At the end of the operation, it is displayed which loggers could be
successfully programmed and which could not. If necessary, repeat the procedure.
INFO
All loggers must be switched on and in wireless range. The ideal distance is
approximately 2 m between PocketServer and loggers.
4.6.2 Single loggers
To program individual loggers, proceed as follows:
► In the start screen, tap LOG N-3.
► Tap Single device.
► Select the desired logger from the Devices list.
► Tap Program.
► Open the Measurement settings drop-down menu and enter the desired
parameters.
 Operation mode
Select the mode (Patrol/Lift&Shift) for the logger.
 Measurement ON
Select when the measurement will start.
 Measurement OFF
Select when the measurement will end.
 Values per measurement
Select how many measurements per measurement day will be recorded.
 Leak threshold
Select the level that will be the alarm threshold.
 Measurement days
Specify the days of the week on which measurements will take place.
 Radio ON
Select the time from which the logger will be available by radio (internal wireless
module is activated).
 Radio OFF
Select the time from which the logger will no longer be available by radio (internal
wireless module is deactivated).
Parameters