User's Manual

LOG N-3
30
4.6 Programming
INFO
The function ‘Programming devices’ does not belong to the PocketServer basic
equipment. It is only available after acquisition and input of a license key in the device.
4.6.1 Logger groups
To program a logger group, proceed as follows:
► In the start screen, tap LOG N-3.
► Tap Patrol mode when you want to program a Patrol group.
Tap Lift&Shift when you want to program a Lift&Shift group.
► Select the desired logger group in the Groups list.
► Tap Program group.
► Open the Measurement settings drop-down menu and enter the desired
parameters.
 Operation mode
The mode (Patrol/Lift&Shift) is preset.
 Measurement ON
Select when the measurement will start.
 Measurement OFF
Select when the measurement will end.
 Values per measurement
Select how many measurements per measurement day will be recorded by each
logger.
 Leak threshold
Select the level that will be the alarm threshold.
 Measurement days
Specify the days of the week on which measurements will take place.
 Radio ON
Select the time from which the logger will be available by radio (internal wireless
module is activated).
 Radio OFF
Select the time from which the logger will no longer be available by radio (internal
wireless module is deactivated).
 Radio days
Specify the days of the week the logger is available via radio.
 Transmission interval
If the Patrol mode is set, select the transmission interval of the logger here.
Parameters