User's Manual

LOG N-3
26
4.3.3 Data of an individual logger
All measured data that has been read and stored from a logger is available in the
PocketServer under the ID of this logger. It does not matter whether the data was
requested by patrolling or by Lift&Shift.
To access a measurement record of a logger, proceed as follows:
► In the start screen, tap LOG N-3.
► Tap Single device.
► Select the desired logger from the Devices list.
► Select the desired measured data from the Data list.
The measured data display opens.
X-axis … course of measurement over time
Y-axis … level in dB
Each bar represents a single measurement.
The height of the bar represents the measured level.
The colour of the bar represents the measured frequency.
0 Hz 3300 Hz
The horizontal green line represents the set alarm threshold.
You can narrow the chart view to any time range.
Option 1:
► Touch a point on the diagram and slide your finger to the side to highlight the desired
area.
Option 2:
► Slide the two control elements to the left/right at the top of the diagram.
Reset:
► Tap Show all to reset the view.
Zoom