User's Manual

LOG N-3
20
4.2 Reading the measured data
4.2.1 Patrol
Requirement:
It is recommended that you connect the optional external wireless module LOG RI+ to
the PocketServer because the limited range of the internal wireless module only allows
a limited patrol.
Procedure:
► In the start screen, tap LOG N-3.
► Tap Patrol mode.
► Select the desired logger group in the Groups list.
► Tap Start Patrol mode.
The patrol begins. The radio LED on the LOG RI+ or on the PocketServer lights up. The
PocketServer searches for loggers of the group within radio range. Once a logger is
detected, its data is received and stored. The screen shows which loggers have already
been received and which have not.
With the Stop Patrol mode button, you can stop the patrol at any time. Otherwise, the
patrol process continues until all the loggers in the group have been recognized and
received. A success message appears on the screen. The radio module is deactivated.
The radio LED goes off.
The received measurement data can be found as a data record in the Data list. It can be
accessed and displayed there.
4.2.2 Reading out a Lift&Shift group
Requirement:
 The loggers must not have been switched off since the measurement.
Procedure:
► In the start screen, tap LOG N-3.
► Tap Lift&Shift.
► Select the desired logger group in the Groups list.
► Tap Read group.
The measurement data is read. The progress of the operation is shown on the screen.
At the end, a message informs you which loggers of the group were read out
successfully and which were not. If necessary, repeat the procedure.
INFO
All loggers must be in wireless range. The ideal distance is approximately 2 m between
PocketServer and loggers.
The received measurement data can be found as a data record in the Data list. It can be
accessed and displayed there.