User's Manual Part 2

Working in Professional mode

6.6.2 Displaying the measured values

In Professional mode the measured data from the loggers is shown as a bar diagram on

the screen just as in Easy mode (see page 42). But, additionally the Professional mode

provides the opportunity to compare the measured data of two loggers.

After the measured data of a logger has been called up, this data can be compared to

the data of another logger in the group.

To do so, select the Compare button. The list of loggers in the workgroup opens on the

screen. Select the table and choose a logger for comparison. The following view

appears on the screen:

The two diagrams show the values of the loggers graphically. The values of the logger

selected first are above, the values of the logger for comparison below.

The leak value of the first and second logger are shown numerically under the diagrams.

After applying the Move Cursor button, you can move the vertical green line in the

diagrams to view the values of the individual recordings in greater detail.

You can use the Mode button to change the measurement unit on the Y-axis in the

diagram (see page 43).

To choose another logger in the group for comparison, use the arrow key to return to the

logger list and select a different logger.

Introduction

Comparing

measured data