User's Manual

Programming the logger
58
6.5 Adjusting the start time of data recording
The point in time, the device shall start logging, has to be defined under Record.
Use the controls to specify a start date and time or click on the Current time button to
get the system date and time of the computer filled in.
If the entered recording start lies in the past, seen from the point in time the device is
receiving the configuration data, the device starts data storage immediately.
6.6 Adjusting the memory mode
The device has 4 MB internal memory.
By checking the Ring memory checkbox under Memory Mode, the logger can be set to
‘ring buffer’ mode. As the memory fills up with data in this mode, the device keeps
logging and the respective oldest value is overwritten.
If the Ring memory checkbox is not selected, measuring data storage stops as soon as
the logger’s memory is full.
6.7 Checking the device status
Some characteristic data about the device are listed under State (e.g. remaining
memory, battery condition, system time, firmware version etc.).
The data has been derived during the last data or configuration readout.
6.8 Finishing the programming
By adding a comment to the Comment field you can take some notes, e.g., on the
location of the device.
Click on the Program button in order to finalize the configuration.
Thereupon, the data is transmitted to the data logger. After the settings have been
saved on the device, a confirmation message appears.
If no connection to the device can be established, an error message appears. Check the
link between device and computer and try to transmit the data again.
Adding a comment
Transmitting the
configuration data