User's Manual

Programming the logger
55
Segment Parameter
Every recorded value is immediately uploaded to the FTP server,
so that the measurement can be monitored from any Internet-
capable computer.
If you select the Configurable via FTP checkbox, the device
checks the FTP server for new configuration data after every
measuring data upload. The new configuration data is
downloaded and immediately installed on the device.
SMS checkbox
and
E-Mail checkbox
To enable the alarm messaging service via SMS (regular status
messages and/or alarm messages), select the SMS checkbox.
To enable the alarm messaging service via e-mail (regular status
messages and/or alarm messages), select the E-Mail checkbox.
Use the radio buttons to select, which messages you want to
receive:
• Alarm only
You will receive alarm messages only
• Status daily
You will receive alarm messages and, beyond, a status
message once a day
• Status weekly
You will receive alarm messages and, beyond, a status
message once a week
Furthermore, specify the point in time and, if required, the day of
the week, the status message shall be sent. (Time values are
specified in 24-hour format.)
Each alarm message contains:
• ID of the sender device
• sending date and time
• number of the measuring channel concerned
• alarm reason and alarm value
Each status message contains:
• ID of the sender device
• sending date and time
• the highest and the lowest measured values of each
measuring channel (seit der letzten Statusmeldung)
• flow rate seit der letzten Statusmeldung (nur bei
Durchflusssensoren)
SMS Destination
Specify up to three mobile phone numbers here to which
summary or alarm messages should be sent.
E-mail Destination
Specify up to two e-mail addresses here to which summary or
alarm messages should be sent.
E-mail Settings Enter the SMTP server address, user name and password for
the e-mail account from which alarm or status messages are to be
sent.