User's Manual

Programming the logger
53
6.4 Configuring the mobile communication
If your logger is equipped with an internal GSM modem, data transfer and alarm
messaging via UMTS / GPRS can be realised.
For this purpose, a UMTS / GPRS-enabled SIM card (data contract) is required which
can be obtained from almost any local mobile network operator.
Usually, all the data required to set up mobile data transfer is provided within the
mobile network contract. Further information can be obtained from the website or
the hotline of the mobile network operator. If necessary, request guidance for
setting up data communication in particular. SebaKMT cannot provide any
specific technical advice in this case.
Proceed as follows to set up data communication via UMTS / GPRS:
Step Description
1
Make sure the logger has been properly prepared for GSM connectivity (see
page 18).
2 In the Communication segment of the window, select the GSM active checkbox
in order to enable the GSM function.
3 Click the Configure GSM button.
Result: The GSM configuration dialogue appears.
4
Enter all the requested data. (You find more information about the configuration
dialogue below in the text).
5 Carry out a GSM test to check the functionality of the GSM connection. (You find
more information about testing the GSM connection below in the text).
6 Confirm and save the settings by clicking the OK button.
Introduction
Procedure