User's Manual

Programming the logger
43
6.1 Selecting the logging interval
You can select the time interval in which the measured values are logged from the
Log Interval drop-down list.
6.2 Configuring a measuring channel
Depending on its configuration, up to 4 sensors can be connected to a logger. In order
to evaluate the logged data in the right way, the logger needs to know which type of
sensor is connected to which channel.
Make sure that the sensor configuration is consistent with the effective connection
setup. Each channel is linked with specific wires of the VK86 connection cable (see
page 23).
Please pay regard to the fixed channel allocations (see page 21) when configuring
internal pressure sensors or sensors with current output.
Make sure you enter the values in the same format as shown in the figures.
First of all, you have to specify which channels are in use (connected to a sensor) during
the upcoming operation period. A channel can be activated by marking the respective
On/Off checkbox exemplified by the following figure:
After a channel has been activated, it has to be specified which type of sensor is
connected to the channel. Click the respective Configure button. The following window
appears:
Introduction
Activating channels
Configuring a channel