User's Manual

Online correlation
66
The changed setting is accepted and will become effective at the next measurement.
The setting will remain valid until it is changed again in the Sensor connection menu or
until the Reset last correlation data command in the System settings menu is used to
reset all measurement data (see page 101).
First, take the Power transmitter which shall be used, go to the first measuring position.
Attach the sensor to the pipe and turn the device on.
Then, take the Correlator and go to the second measuring position. Attach the sensor
which is connected to the Correlator to the pipe.
The measurement can now be started using the button in the main menu.
Before the next Online measurement with two Power transmitters can be performed, the
Sensor connection setting has to be reset.
For this, access the Sensor connection menu and tap the RF button beneath A as well
as the RF button beneath B and confirm by pressing OK.
If you use the Reset last correlation data command in the System settings
menu prior to a new correlation, the Sensor connection setting will be reset to
RF-RF at the same time.
Perform measurement
Reset the
"Sensor connection"
setting