User's Manual

Sensor management
58
Step Description
3
Enter the identification number of the sensor in question.
Via manual input:
• Enter the ID.
• On the right, a drop-down list
appears. There, select whether the
device in question is a
Multi sensor (COR MS-3) or a
Power transmitter (COR PT-3).
• Confirm with the ENTER button.
Via „Automatic detection“:
• Briefly contact the I/O field of the
Multi sensor with a magnet or press
the I/O button of the
Power transmitter.
• On the Correlator screen, confirm
the ID displayed with Accept.
• Add another sensor or conclude
with Finish.
Result: The display returns to the Sensor management menu.
The relevant device now appears in the list.
Every Multi sensor receives a consecutive number from 1 to 8, according to the
registration order. This number is displayed in the first column of the table. The
number will be used in various functions of the Correlator to represent this sensor.
7.4 Replace / Delete sensors
You can remove a single sensor from the pool and replace it by a new sensor.
Proceed as follows:
Step Description
1
In the list, tap on the applicable sensor.
2 Tap the Replace button.
3 Answer the question displayed with Yes.
Result: The menu for entering device IDs opens.
4
Enter the identification number of the sensor which you want to add new to the
sensor pool. Use the key pad displayed or the "Automatic detection".
Result: The display returns to the Sensor management menu. The new sensor
now appears in the list. It takes over the number of the replaced sensor.
To remove a sensor from the pool, proceed as follows:
Step Description
1
In the list, tap on the applicable sensor.
2 Tap the Delete button.
3 Answer the question displayed with Yes.
Result: The sensor is removed from the list.
Replace a sensor
Delete a sensor