User's Manual

CorreluxView Software
123
19.2 Basic settings
You should always check basic CorreluxView software settings and adjust these if
necessary before using the application.
To open the system settings menu, proceed as follows:
Step Description
1
Click on the CorreluxView symbol at the top left of the menu bar.
2 Click on Settings in the context menu.
Result: The system settings menu opens.
19.2.1 Storage location for application database
In the Data location segment the storage location for the CorreluxView application
database is shown. This target directory was created upon initial installation of the
software. All measurement data sets that are imported to the CorreluxView application
by the Correlator are saved under this location.
You can use the Open button to open the directory.
You can use the Browse button to specify a new storage location. The application will
display a window allowing you to navigate to the new target directory for the application
database. When you are finished, click OK to confirm your change.
19.2.2 GPS receiver port
The CorreluxView application allows you to connect a GPS receiver to your computer so
you can use the software to specify GPS coordinates for sensors.
Use the drop-down menu in the GPS device segment to select the connection port for
your GPS receiver.
19.2.3 System of units
You can select whether Metric or Imperial (Anglo-American) units of measurement
are to be used in your CorreluxView application.
Open the Correlation tab. Use the drop-down menu in the Unit segment.