User's Manual

Firmware update
118
Step Description
Result: The update-file is transferred to the device in question. There, the new
firmware is installed and initialized. Subsequently, the device switches itself off
and on again.
A bar on the Correlator screen shows the progress of the process. Finally, the
message "Firmware successfully updated" appears.
7
Tap the button to call the next sensor from the sensor pool.
Result: The Number and the ID of this device are displayed.
8 Tap the Update button.
Result: The firmware is transferred and installed. The updated device switches
itself off and on again. After all, the message "Firmware successfully updated"
appears on the Correlator screen.
9 Tap the OKbutton to conclude the firmware update.
Use the Back button or the ESC pushbutton to return to the Start menu.
To check if a device really is operated with the new firmware read the configuration of
the device in question using the Correlator (see page 111). In the displayed menu,
check the FW version line.
If you tapped on Select device, proceed as follows:
Step Description
5
Switch on the device which is to be updated.
6
Enter the ID of this device.
(Manual entry: use the numeric keypad, confirm with ENTER button
Automatic detection: press the I/O pushbutton of the Power transmitter briefly or
contact the I/O field of the Multi sensor briefly using a magnet, confirm the ID
displayed with the Accept button)
Result: A new menu opens. Type and ID of the device and the new firmware
version are once again displayed.
Updating
a single device